barqy
Member-
Content Count
29 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout barqy
-
Rank
Junior Member
Previous Fields
-
Headphones
akg k81dj
-
Headphone amplifiers
govibe 5
-
Sources
4g ipod
-
true if you have a soldering iron, buy a female 1/4" jack, add some wire inbetween, and terminate to 1/8".
-
weird, cat5 cable here (at dollar stores) is stranded. either way, solid/stranded, both work as interconnect
-
cat5 works stranded copper after all...
-
the above is 22awg solid silver (99.99%) insulated w/ teflon (clear) i prefer silk or cotton insulation over teflon thoughl
-
cool here's a silver dock i made aw hile back:
-
try percyaudio.com although i haven't ordered from them before, i heard 'good' thigns over at head-fi.
-
to fill the hole use several layers of heat shrink to 'fill it out' use 20-24awg wire and you should be fine... what plugs are you using? i recommend hot glueing the connector down too so the pins are 'stablized', otherwise it'll get shorted real fast. post pix.
-
itouch works with Ipod LOD (same pin out)~ just that the iphone is problematic (i think?)
-
does the HD590 leak sound (like 595?) if so...portable solution might not be good. unless you want the entire bus listening to your tunes too
-
what about the little tube II+? what do you all think about that amp? it has a warm sound and the price is good darkvoice probably blows it out of the water thoughn? I haven't tried both (little tube II is coming in though!) Little tube II can be had for around $100USD i think (used) cheers
-
^ agreed. maybe your DT phones have a problem w/ the 1/4" connector You could always reterminate the 1/4 to 3.5mm If the adapater your using is the same one i have for my hd595, i'd advise against using it too much b/c there is no extra wire for the adapter which puts a lot of strain on your jack
-
dont you find the ep630s a bit muddy? similar to sony ex71 sound?
-
hey no problem you probably found/know this already but here is the pinout for the ipod dock: http://pinouts.ru/PortableDevices/ipod_pinout.shtml
-
cool beans~ post pictures when finished so we can all enjoy if you need help (verbally), I can assist you for making ipod dock since i have made a few before. i would suggest removing all the pins except 2,3,4 (ground,right,left) to minimize any interference and makes it a lot easier to work with... you could leave pin 1 too if you want to ground/bridge to pin 2 (but i never do) good luck!