Jump to content
Sign in to follow this  
Brisrascal

Damaged PCB

Recommended Posts

pics

 

but I guess u want to desolder your POT, but damage one of them...

 

wire jump bottom PCB should be still ok

Share this post


Link to post
Share on other sites

trace the route of the messed up hole, find a place where it is shorted to and chose to the surface. Remove some of the photo resist and solder a wire to it.

Share this post


Link to post
Share on other sites

[attachmentid=4635]

[attachmentid=4636]

[attachmentid=4637]

 

Attached are the images of the PCB in question. :) Will work out how to post it online soon. Considered jumping it but its connected to the tube connector so am not too sure as to whether it will work. Therefore did not go ahead.

post-4107-1310880789_thumb.jpg

post-4107-1310880836_thumb.jpg

post-4107-1310880877_thumb.jpg

Share this post


Link to post
Share on other sites

the middle pin is screwed up right?

 

take a photo of pic3 on the other side, or trace the middle pin leads to where, then wire to it

Share this post


Link to post
Share on other sites

The other side of the pin is occupied by the pot that is on the last pic. I was thinking of jumpering a wire from that middle pin it where it teminates (which is on the tube socket) however am not particularly sure of its effect as the pot is used to adjust the voltages heading/coming from it. The setup is from a uncompleted tube preamp project that I was thinking of restarting again. Anyone know of a place where i can send it to for final touch up? :) Still thinking of working out the cabinet design and fabricating it.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×
×
  • Create New...