alvin1118 0 Report post Posted January 13, 2009 Recable Guide for JVC HA-RX700 Step 1. Remove the earpads, unscrew the three screws. Driver units will then be able to removed Closer look of the driver 2. Remove the stock tiny cable, replace with desired cable. Note that i drilled the right side to optimize recabling for both drivers. Take note of the polarity too. 3. Solder the replaced cable on the PCB terminal. Again, apply good soldering practice 4. The headphone cover is made of ABS plastic, maybe applying some sound isolation material will help improving the sound further? 5. Done. Share this post Link to post Share on other sites
hellfire112 0 Report post Posted January 14, 2009 which cable was used for the recable? Share this post Link to post Share on other sites
Morgan Wu 0 Report post Posted January 14, 2009 Looks like the Mogami alvin used to recable his yuin. Share this post Link to post Share on other sites