kwhv 0 Report post Posted July 18, 2005 Hi everyone, I'm a newbie here and i'm trying to build a cmoy headamp but dunno what vol pot to use. The ones at SLT are rather big. I'm looking for smaller ones with 3-4mm diameter shaft for PCB mount (like the ones in various cmoy projects). Saw some at farnell and rs components but very limited. Must I use the dual pot ones or can I use the single ones and solder both channels to it? Thank you for your attention. Share this post Link to post Share on other sites
heady 0 Report post Posted July 18, 2005 Hi everyone, I'm a newbie here and i'm trying to build a cmoy headamp but dunno what vol pot to use. The ones at SLT are rather big. I'm looking for smaller ones with 3-4mm diameter shaft for PCB mount (like the ones in various cmoy projects). Saw some at farnell and rs components but very limited. Must I use the dual pot ones or can I use the single ones and solder both channels to it? Thank you for your attention. In Singapore, the only place with proper pots and even then, very little choice, is at Farnell. You will need a dual log taper pot. Sometimes it is called A taper, eg 10KA2. Share this post Link to post Share on other sites