digi01 0 Report post Posted September 7, 2005 (edited) photo. Edited September 7, 2005 by digi01 Share this post Link to post Share on other sites
digi01 0 Report post Posted September 7, 2005 all resistors 被焊接在IC 的下面,for reduce feedback distance and signal route. Share this post Link to post Share on other sites
huangyong 0 Report post Posted October 1, 2005 more pic pls.. Share this post Link to post Share on other sites
N@Z 0 Report post Posted October 1, 2005 How about putting in more descriptions about the amp for us less technically inclined sorts. Share this post Link to post Share on other sites
Kube 0 Report post Posted October 1, 2005 Looks interestingly simple...being that you used a common breadboard. Share this post Link to post Share on other sites
Firefox 0 Report post Posted December 19, 2005 For those who can't read chinese, he states that all resistors were soldered under the board to reduce any interference. From what I can see, it looks to be a simple buffered cmoy type design. Share this post Link to post Share on other sites
digi01 0 Report post Posted February 23, 2006 How about putting in more descriptions about the amp for us less technically inclined sorts. sorry I am too late response.yesteryear I am very busy in decorating. the pocket amp is a cmoy&buffer combo design without outer loop feedback.I set up ad811 for the current buffer. Zang Share this post Link to post Share on other sites
