PCB Fabrication - recommendation required

[Northern Oak 0]

hi all,

 

Anyone can recommend PCB fabrication in Singapore? I would like to spin a discrete regulator power supply board? Thanks!

 

Regards,

Noak

[heady 0]

Sounds interesting to me too. The last time I think I had to pay USD40 to make one pcb which was cut into 6 pieces. This from a factory in East Europe. Shipping was another matter. That pcb was for a phono preamp.

[mouz 0]

I've got one that's not in SG but it's recommended to me by a friend who's teaching electronics in a school here.

http://ourpcb.com/

 

This one's in Malaysia but not too sure if the price's reasonable

http://www.custompcb.com/index.html

Edited May 21, 2008 by mouz

[Northern Oak 0]

I've got one that's not in SG but it's recommended to me by a friend who's teaching electronics in a school here.

http://ourpcb.com/

 

This one's in Malaysia but not too sure if the price's reasonable

http://www.custompcb.com/index.html

 

Thanks, mouz! Will check them out!

 

[mouz 0]

u're welcome

Edited May 21, 2008 by mouz