Northern Oak 0 Report post Posted May 21, 2008 hi all, Anyone can recommend PCB fabrication in Singapore? I would like to spin a discrete regulator power supply board? Thanks! Regards, Noak Share this post Link to post Share on other sites
heady 0 Report post Posted May 21, 2008 Sounds interesting to me too. The last time I think I had to pay USD40 to make one pcb which was cut into 6 pieces. This from a factory in East Europe. Shipping was another matter. That pcb was for a phono preamp. Share this post Link to post Share on other sites
mouz 0 Report post Posted May 21, 2008 (edited) I've got one that's not in SG but it's recommended to me by a friend who's teaching electronics in a school here. http://ourpcb.com/ This one's in Malaysia but not too sure if the price's reasonable http://www.custompcb.com/index.html Edited May 21, 2008 by mouz Share this post Link to post Share on other sites
Northern Oak 0 Report post Posted May 21, 2008 I've got one that's not in SG but it's recommended to me by a friend who's teaching electronics in a school here. http://ourpcb.com/ This one's in Malaysia but not too sure if the price's reasonable http://www.custompcb.com/index.html Thanks, mouz! Will check them out! Share this post Link to post Share on other sites
mouz 0 Report post Posted May 21, 2008 (edited) u're welcome Edited May 21, 2008 by mouz Share this post Link to post Share on other sites