adhoc 0 Report post Posted December 10, 2006 As per thread title. Where do I go, and how much will it cost me? FWIW, enclosure will be Al, and max thickness is 6mm. Most holes will be in 2mm thickness Al. Share this post Link to post Share on other sites
pegasus21 0 Report post Posted December 10, 2006 If you can, I think investing in a hand drill would be good. Share this post Link to post Share on other sites
loop_ 0 Report post Posted January 25, 2007 A bit of a late reply, but if you haven't left sg yet, you can ask someone from NUS who does engineering or something. There is a workshop there where you can do so fongalv very kindly offered to help me once but I decided to get a pre-drilled enclosure instead. Not sure if he still frequents this forum though. Share this post Link to post Share on other sites
zer061zer0 0 Report post Posted February 1, 2007 As per thread title. Where do I go, and how much will it cost me? FWIW, enclosure will be Al, and max thickness is 6mm. Most holes will be in 2mm thickness Al. Just wondering if u have manged to find a way to cut yours? I am looking for some help too. Share this post Link to post Share on other sites