nekatrall

nooooooooooooooooooooooooo

100 to 200 sgd? if so can try vr zone got a whole lot of x10 and sf10 u just add 20 sgd see if can bargain haha

the best and only way go and test see if the synergy with ur gear is good and also if u like the sound sig

didnt know daiso sells heatshrink not sure if u can get fr SP EEE store usually i get mine fr slt

no need to thank me hahahaha just sharing knowledge

yeah but not a gd idea to thicken the wire microphonics will be affected if u can get broken beats tt should be better since its flat cable and got mic colour also with match ahah

if u want lesser wires running ard can share the ground wire = negative http://www.engadget.com/2007/07/05/diy-iph...ud-replacement/

well some ppl did modify via using an existing iphone earphones so mic not an issue plus its dirt cheap to wire one side not so easy plus convention is to wire on left side u can go over the top make sure got extra length for adjustment if not too tight heat shrink or cable tie to the hinges for cable management

the lame imageshack conspiracy changed to photobucket more effective thanks for the heads up

since the top case and front plate was slightly misaligned i decided to remachine and use brass plate instead as it would work as a better heatsink too this was done on 6 dec 2011 then the next day some laser cut deco tapping the holes planing which turned out to be a bad idea may be sand blasting it instead modified cupboard knob to be the tuning knob leading to today some remachining cos the switch cant fit another tentative outlook with tubes wires using 18awg spc abit stiff fully done up for now now need to wait for the sandblasting machine to be cleared to finish should take 2 work days left 1. sandblast+lacquer(24hrs to dry) 2. wire everything up epoxy the heatsink and done

appearing at lots of audiophile sites just got a listen of hd650 hope this is more magical

bluetooth wont be good due to their wireless bandwidth

hmm fine on my preview

Got this kit off someone finally got time to start building it will try to update building so far manage to solder all parts with no problems and if money and resources is not an issue it the heatsink will be taken from a cpu tower heatsink to give it a more steam punk look slight alignment issue but not a real problem

haha nice u can always go stereo or jaben to audition

looks like i found their oem manufacturer http://www.woodheadphones.com/products/es-666

see if i can make woodies for my friend and post here if u like can go thru me?

xb1000 tooo bassy and i think requires an amp to power it properly

http://item.taobao.com/item.htm?id=12360225511 if really ultrasone ed9 driver i think its worth it

http://item.taobao.com/item.htm?id=1229701...=&cm_id=&pm_id=

ue tf10p vi

haha try the sony xb700

still looking

im in anytime at least getting 2 pairs

well u nvr try u nvr know i still wanna get those drivers for my personal headphones mod and im not buying it as a grado replacement